GROHE Blue Mono Pure Service Manual download pdf (Page 7)

The control unit of the GROHE Blue

fitting is set for operation

with the 600 liter filter cartridge at the factory.

For operation with other filter cartridges the control unit must be

set out.

Setting filter size, see fold-out page II, Fig. [7].

U button for filter size selection:

• Press and hold U button once until the currently setted

value (e. g. F1) flashes in the display

• Press the U button and select the required value appears

- F4: 600 liters 40 404 001

- F5: 1,500 liters 40 430 001

- F6: 3,000 liters 40 412 001

- F7: 600 liters 40 691 001 (Magnesium)

- F8: 3.000 liters 40 547 001 (Activ carbon)

• Press and hold the U button until the required value stops

flashing

• Release the U button:

The remaining filter capacity is displayed.

The fitting is now fully installed and ready for operation.

Note: The various filter cartridges can be ordered at

www.grohe.com.

Maintenance

Resetting filter capacity after changing filter cartridge, see

fold-out page II, Fig. [7].

 button for filter replacement reset:

• Press and hold  button until rF flashes in the display.

• Release the  button and press again until rF stops

flashing.

• Release the  button.

The remaining filter capacity is reset and then displayed

again.

Warning

Risk of damage:

Always disconnect the power supply before performing

maintenance work on the system. The plug-in connectors

can then be disconnected, see fold-out page II, Fig. [7].

Inspect and clean all components and replace if necessary.

I. Mousseur (13 199), see fold-out page I.

Assemble in reverse order.

II. Solenoid valve (42 390), see fold-out page I.

Assemble in reverse order.

Service

Note the Fault / Cause / Remedy table for information on

eliminating problems.

If EE flashes or the problem cannot be rectified, interrupt the

power supply and consult a specialist installer or contact the

GROHE Service Hotline via email under TechnicalSupport-

[email protected].

Replacement parts

See fold-out page I (* = special accessories).

Care

For directions on the care of this fitting, please refer to the

accompanying Care Instructions.

Environment and recycling

Used filter cartridges can be disposed of hazard-free in

domestic waste.

Fault Cause Remedy

Filtered water not

flowing

• Water supply interrupted

• Solenoid valve defective

• Plug-in connector of solenoid valve

without contact

- Open shut-off valves

- Replace solenoid valve

- Attach plug-in connector

No filtered water,

Blue

handle flashes

red, E4 in the display

• Fitting and control unit not synchronized - Synchronise with one another, see section

Installation

No filtered water,

Blue

handle flashes

red, E6 in the display

• Values range does not concur - Synchronise with one another, see section

Installation

E7, E8 in the display • Filter capacity exceeded - Change filter cartridge immediately

Indicator lamps

do not flash/flash

continuously

• Control not recognised - With mains plug connected, disconnect plug-in

connector, wait 30 seconds and reconnect

1 2 3 4 5 6 7 8 9 10 11 12 ... 63 64

Comments to this Manuals

No comments

GROHE Blue Mono Pure Service Manual Page 7

Comments to this Manuals

Related products and manuals for Faucets GROHE Blue Mono Pure